Jump Survey

Help, problems, suggestions about Waterski Homologation software
rodgerlogan
Posts: 3
Joined: Thu Sep 26, 2013 4:45 pm

Jump Survey

Post by rodgerlogan »

Your jump survey program, if sighting only the “R” on the jump ramp, provides no calculations. I was relocating a jump course in Georgia (U.S. not Europe) yesterday. Unfortunately, the owner was unable to launch his jump because of an under carriage mobilizing failure. The make-shift axle collapsed. He asked if I could, at least, put the buoys in and provide a jump ramp locating buoy with which he could position the jump once he got it into the water. Your program, to my knowledge has no such provision. Additionally you cannot use the program to position the 150, 180 and 210 buoys without R1/R2 entries. The program will provide width information in relation to the 15M line, but no length.

It would be very helpful if an “R” entry would provide all of the calculations except, of course, ramp angle. N’est-ce pas? Est-ce possible?
Rodger Logan
nigeltalamo
Posts: 2
Joined: Mon Sep 14, 2009 10:00 am

Re: Jump Survey

Post by nigeltalamo »

The easy way to set R and find the positions of 150, 180 and 210 is to use the calculations provided by Hervé Tilloy. He shared this some years ago. I have sent the calculations to Rodger. If anyone else needs them, please ask me and I will send.
emmanuel
Site Admin
Posts: 276
Joined: Fri May 20, 2005 8:34 am
Contact:

Re: Jump Survey

Post by emmanuel »

Hi Rodger,

You can enter for both R1 and R2 the value of R, and you will get all measurements from R.
Simple, n'est-ce pas ?

Emmanuel
Post Reply